Il demande les connaissances professionnelles pour passer le test Juniper JN0-532. Si vous manquez encore ces connaissances, vous avez besoin de Pass4Test comme une resourece de ces connaissances essentielles pour le test. Pass4Test et ses experts peuvent vous aider à renfocer ces connaissances et vous offrir les Q&As. Pass4Test fais tous efforts à vous aider à se renforcer les connaissances professionnelles et à passer le test. Choisir le Pass4Test peut non seulement à obtenir le Certificat Juniper JN0-532, et aussi vous offrir le service de la mise à jour gratuite pendant un an. Si malheureusement, vous ratez le test, votre argent sera 100% rendu.
On peut télécharger quelques parties de Q&A gratuites dans le site Pass4Test à propos de test Certification Juniper JN0-532. Vous pouvez tester notre fiabilité via le démo. Choisir Pass4Test, c'est-à-dire que vous êtes proche d'un pic ensuite de l'Industrie IT.
Le test Juniper JN0-532 est bien populaire dans l'Industrie IT. Mais ça coûte beaucoup de temps pour bien préparer le test. Le temps est certainemetn la fortune dans cette société. L'outil de formation offert par Pass4Test ne vous demande que 20 heures pour renforcer les connaissances essentales pour le test Juniper JN0-532. Vous aurez une meilleure préparation bien que ce soit la première fois à participer le test.
Code d'Examen: JN0-532
Nom d'Examen: Juniper (FWV,Specialist (JNCIS -FWV))
Questions et réponses: 146 Q&As
Est-ce que vous vous souciez encore de réussir le test Juniper JN0-532? Est-ce que vous attendez plus le guide de formation plus nouveaux? Le guide de formation vient de lancer par Pass4Test peut vous donner la solution. Vous pouvez télécharger la partie de guide gratuite pour prendre un essai, et vous allez découvrir que le test n'est pas aussi dur que l'imaginer. Pass4Test vous permet à réussir 100% le test. Votre argent sera tout rendu si vous échouez le test.
JN0-532 Démo gratuit à télécharger: http://www.pass4test.fr/JN0-532.html
NO.1 What must be configured differently for a route-based VPN and a policy-based VPN?
A.proxy-id
B.proposals
C.remote gateway type
D.binding the tunnel interface
Answer: D
Juniper JN0-532 examen certification JN0-532 certification JN0-532
NO.2 Which ScreenOS CLI command is necessary for configuring IGMP on interface ethernet0/1?
A.set igmp interface ethernet0/1
B.set multicast interface ethernet0/1
C.set interface ethernet0/1 igmp router
D.set igmp interface ethernet0/1 enable
Answer: C
certification Juniper certification JN0-532 certification JN0-532 certification JN0-532 JN0-532 examen
NO.3 You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS
using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr.
What is the status of the virtual router after you create the VSYS?
A.The router will be the default router but will no longer be shared.
B.The router will be the default router and will still have a shareable status.
C.The system will not let you use a shared virtual router when you create a new VSYS. The initial virtual
router must be private.
D.The system will not create a private vr for the VSYS but will assign the untrust-vr as the default router.
The shared Virtual router will not be the default router.
Answer: B
Juniper certification JN0-532 JN0-532 JN0-532 examen JN0-532
NO.4 Click the Exhibit button.
In the exhibit, what is the source IP address of the multicast traffic?
A.236.1.1.1
B.10.10.10.1
C.20.20.20.10
D.20.20.20.200
Answer: B
Juniper examen JN0-532 certification JN0-532 JN0-532 examen JN0-532 examen certification JN0-532
NO.5 Review the exhibit.
Which two of the following elements must be configured on the ScreenOS device in order to support
PIM-SM? (Choose two)
A.A multicast control policy
B.A bootstrap router process
C.A unicast routing protocol
D.A static RP
Answer: AC
Juniper certification JN0-532 JN0-532 JN0-532
NO.6 Click the Exhibit button.
In the exhibit, which two can be determined about the VPN? (Choose two.)
A.NAT-traversal is enabled.
B.The rekey interval is 8 hours.
C.This device initiated the Phase 1 negotiations.
D.The certificate used in this exchange is set to never expire.
Answer: BC
Juniper JN0-532 examen JN0-532 certification JN0-532
NO.7 Click the Exhibit button.
In the exhibit, what is the address of the multicast receiver?
A.234.9.8.42
B.192.168.10.2
C.192.168.20.10
D.192.168.20.200
Answer: D
Juniper JN0-532 certification JN0-532 JN0-532 certification JN0-532
NO.8 What must be enabled to protect Phase 2 key exchanges?
A.Phase 1 PFS
B.Phase 2 SHA
C.Phase 2 3-DES
D.Phase 2 DH key exchange tiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: D
certification Juniper JN0-532 JN0-532
NO.9 During main mode negations a failure has occurred while using IKE certificates.
Which message pair would you review to troubleshoot this failure?
A.messages 1 & 2
B.messages 2 & 3
C.messages 3 & 4
D.messages 5 & 6
Answer: D
Juniper certification JN0-532 JN0-532 certification JN0-532 JN0-532
NO.10 Click the Exhibit button.
Review the exhibit. Track-ip has failed on the device, but the device did not fail over to the second unit in
the cluster:
Why has failover not occurred?
A.The physical interfaces have not failed.
B.The track-ip interval is not sufficient to cause failover.
C.The track-ip address weight is not sufficient to cause failover.
D.The track-ip address threshold is not sufficient to cause failover.
Answer: C
Juniper JN0-532 JN0-532 JN0-532 examen
NO.11 To which three ScreenOS components can a policy-based routing policy be bound? (Choose three.)
A.zone
B.policy
C.interface
D.virtual router
E.virtual system
Answer: ACD
Juniper examen JN0-532 JN0-532 examen
NO.12 Which command is used to verify that IGMP is running correctly?
A.get route igmp
B.get igmp query
C.set igmp query interface e0/1
D.exec igmp interface e0/1 query
Answer: D
Juniper examen JN0-532 JN0-532 examen certification JN0-532 JN0-532
NO.13 Click the Exhibit button.
In the exhibit, the firewall administrator at the Storefront is complaining that when the communication to
the DataCenter1 fails, the preexisting transfers and applications are dropped when the traffic is switched
to DataCenter2.
Which statement explains this behavior?
A.SYN checking is enabled in the tunnel.
B.The weight value for the DataCenter2 is too high.
C.VPN monitor is misconfigured in the DataCenter2.
D.Phase 1 and Phase 2 negotiations to DataCenter2 did not occur on time.
Answer: A
Juniper JN0-532 JN0-532 examen JN0-532 JN0-532 examen JN0-532
NO.14 Which three statements are true regarding IKE Phase 1? (Choose three.)
A.Placing the SA proposal list in message 1 is an option.
B.The digital certificate is used to decrypt the session key.
C.The DH key exchange is used to validate the session key.
D.The DH key exchange and digital certificates are both optional.
E.The proxy-id is used to determine which SA is referenced for the VPN.
Answer: ABC
certification Juniper certification JN0-532 certification JN0-532 JN0-532
NO.15 Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: AD
Juniper JN0-532 JN0-532 examen
NO.16 Review the exhibit.
You've been asked to build a route-based hub and spoke network, with policy control for traffic travelling
from spoke to spoke. Which two of the following configuration options will meet this requirement?
(Choose two.)
A.Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
B.Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
C.Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
D.Create separate tunnel interfaces at the hub and place them in different zones, then create policies at
the hub.
Answer: BD
Juniper JN0-532 examen JN0-532 certification JN0-532
NO.17 Which CLI command identifies the multicast sources visible to your ScreenOS device?
A.get route pim
B.get igmp source all
C.exec pim interface all query
D.get vrouter trust-vr protocol pim
Answer: D
certification Juniper JN0-532 certification JN0-532 JN0-532
NO.18 You have configured the following on your device.
set address trust MyPC 10.1.1.5/32
set address untrust CorpNet 10.10.0.0/16
set policy from trust to untrust MyPC CorpNet any permit
set int tunnel.1 zone untrust
set int tunnel.1 ip unnumbered int bgroup1
set ike gateway GW address 1.1.1.1 outgoing-interface e0/1 preshare Secret sec-level standard
set vpn VPN gateway GW sec-level standard
The tunnel interface is down, so the VPN cannot function properly. What is the problem?
A.The policy needs to have the action tunnel.
B.The VPN needs to be bound to the tunnel interface.
C.The tunnel interface needs to be placed in the trust zone.
D.The tunnel interface needs to be associated with the interface in the untrust zone.
Answer: B
Juniper certification JN0-532 certification JN0-532
NO.19 You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
What will be the resulting output in the debug for which this was created?
A.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be
captured
B.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be
captured
C.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will
be captured
D.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will
be captured
Answer: C
Juniper JN0-532 certification JN0-532 JN0-532
NO.20 Which three OSPF parameters are interface parameters? (Choose three.)
A.cost
B.priority
C.neighbor list
D.summarization
E.advertise default route
Answer: ABC
certification Juniper JN0-532 examen certification JN0-532 certification JN0-532
Pass4Test est un site professionnel qui répondre les demandes de beaucoup clients. Les candidats qui ont déjà passer leurs premiers test Certification IT ont devenus les suivis de Pass4Test. Grâce à la bonne qualité des documentations, Pass4Test peut aider tous candidats à réussir le test Juniper JN0-532.
没有评论:
发表评论